Managing Faults on Avaya Virtual Services Platform 7200 Series and 8000 Series Version 4.2.1

Configuring logging
Configure logging to determine the types of messages to log and where to store the messages.
About this task
Note:
The platform logs CLILOG and SNMPLOG as INFO. Normally, if you configure the logging level
to WARNING, the system skips all INFO messages. However, if you enable CLILOG and
SNMPLOG the system logs ACLI Log and SNMP Log information regardless of the logging level
you set. This is not the case for other INFO messages.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Define which messages to log:
logging level <0-4>
3. Write the log file from memory to a file:
logging write WORD<1-1536>
4. Show logging on the screen:
logging screen
Example
Switch:1 logging level 0
Switch:1 logging write log2
Switch:1 logging screen
Variable definitions
Use the data in the following table to use the logging command.
Table 12: Variable definitions
Variable Value
level <0-4> Shows and configures the logging level. The level is one of the
following values:
• 0: Information — all messages are recorded
• 1: Warning — only warning and more serious messages are
recorded
Table continues…
Configuring logging
June 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 85
Comments on this document? [e-mail]