Managing Faults on Avaya Virtual Services Platform 7200 Series and 8000 Series Version 4.2.1
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this release
- Chapter 3: Fault management fundamentals
- Chapter 4: Key Health Indicators using ACLI
- Chapter 5: Key Health Indicators using EDM
- Chapter 6: Link state change control using ACLI
- Chapter 7: Link state change control using EDM
- Chapter 8: RMON configuration using ACLI
- Chapter 9: RMON configuration using EDM
- Enabling RMON globally
- Enabling RMON on a port or VLAN
- Enabling RMON1 history
- Disabling RMON1 history
- Viewing RMON1 history statistics
- Creating an RMON1 alarm
- Creating an RMON1 port history alarm
- Viewing RMON1 alarms
- Deleting an RMON1 alarm
- Creating a default RMON1 event
- Creating a nondefault RMON1 event
- Viewing RMON1 events
- Viewing the RMON log
- Deleting an event
- Viewing the protocol directory
- Viewing the data source for protocol distribution statistics
- Viewing protocol distribution statistics
- Viewing the host interfaces enabled for monitoring
- Viewing address mappings
- Viewing the data source for host statistics
- Viewing network host statistics
- Viewing application host statistics
- Chapter 10: Viewing statistics using ACLI
- Chapter 11: Viewing statistics using EDM
- Chapter 12: Log and trap fundamentals
- Chapter 13: Log configuration using ACLI
- Chapter 14: Log configuration using EDM
- Chapter 15: SNMP trap configuration using ACLI
- Chapter 16: SNMP trap configuration using EDM
- Chapter 17: RMON alarm variables
- Glossary
Category Subcategory Variable Definition
including framing characters
detected by the high-count (64-
bit) register.
rcStatMltIfExtnIfHCInUcastPkts The number of packets delivered
by this MLT interface to a higher
MLT that were not addressed to a
multicast or broadcast address as
detected by the high-count (64-
bit) register.
rcStatMltIfExtnIfHCInMulticastPkt The total number of multicast
packets delivered to this MLT
interface detected by the high-
count (64-bit) register.
rcStatMltIfExtnIfHCInBroadcastPkt The total number of broadcast
packets delivered to this MLT
interface detected by the high-
count (64-bit) register.
rcStatMltIfExtnIfHCOutOctets The total number of octets
transmitted from the MLT
interface, including framing
characters.
rcStatMltIfExtnIfHCOutUcastPkts The number of packets
transmitted by this MLT interface
to a higher MLT that were not
addressed to a multicast or
broadcast address as detected by
the high-count (64-bit) register.
rcStatMltIfExtnIfHCOutMulticast The total number of packets that
higher-level protocols requested
be transmitted, and that were
addressed to a multicast address
at this sublayer, including those
that were discarded or not sent
registered by the high-count (64-
bit) register.
rcStatMltIfExtnIfHCOutBroadcast The total number of packets that
higher-level protocols requested
be transmitted, and that were
addressed to a broadcast
address at this sublayer, including
those that were discarded or not
sent registered by the high-count
(64-bit) register.
RMON alarm variables
June 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 127
Comments on this document? infodev@avaya.com










