Managing Faults on Avaya Virtual Services Platform 7200 Series and 8000 Series Version 4.2.1
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this release
- Chapter 3: Fault management fundamentals
- Chapter 4: Key Health Indicators using ACLI
- Chapter 5: Key Health Indicators using EDM
- Chapter 6: Link state change control using ACLI
- Chapter 7: Link state change control using EDM
- Chapter 8: RMON configuration using ACLI
- Chapter 9: RMON configuration using EDM
- Enabling RMON globally
- Enabling RMON on a port or VLAN
- Enabling RMON1 history
- Disabling RMON1 history
- Viewing RMON1 history statistics
- Creating an RMON1 alarm
- Creating an RMON1 port history alarm
- Viewing RMON1 alarms
- Deleting an RMON1 alarm
- Creating a default RMON1 event
- Creating a nondefault RMON1 event
- Viewing RMON1 events
- Viewing the RMON log
- Deleting an event
- Viewing the protocol directory
- Viewing the data source for protocol distribution statistics
- Viewing protocol distribution statistics
- Viewing the host interfaces enabled for monitoring
- Viewing address mappings
- Viewing the data source for host statistics
- Viewing network host statistics
- Viewing application host statistics
- Chapter 10: Viewing statistics using ACLI
- Chapter 11: Viewing statistics using EDM
- Chapter 12: Log and trap fundamentals
- Chapter 13: Log configuration using ACLI
- Chapter 14: Log configuration using EDM
- Chapter 15: SNMP trap configuration using ACLI
- Chapter 16: SNMP trap configuration using EDM
- Chapter 17: RMON alarm variables
- Glossary
Category Subcategory Variable Definition
Other rcTblArNoSpace The number of entries not added
to the address translation table
due to lack of space.
snmpInAsnParseErrs.0 The total number of ASN.1 or
BER errors encountered by the
SNMP protocol entity when it
decodes received SNMP
messages.
rcStgPortInBadBpdus The number of bad BPDUs
received by this port.
dot1dTpPortInDiscards Count of valid frames received
that were discarded (that is,
filtered) by the forwarding
process.
Traffic Interface ifInOctets The total number of octets
received on the interface,
including framing characters.
ifInMulticastPkts The number of packets, delivered
by this sublayer to a higher
sublayer, that are addressed to a
multicast address at this sublayer.
For a MAC layer protocol, this
number includes both Group and
Functional addresses.
ifInBroadcastPkts The number of packets, delivered
by this sublayer to a higher (sub)
layer, that are addressed to a
broadcast address at this
sublayer.
ifInUnkownProtos For packet-oriented interfaces,
the number of packets received
through the interface that are
discarded because of an
unknown or unsupported
protocol. For character-oriented
or fixed-length interfaces that
support protocol multiplexing, the
number of transmission units
received through the interface
that are discarded because of an
unknown or unsupported
protocol. For any interface that
does not support protocol
multiplexing, this counter is
always 0.
Table continues…
RMON alarm variables
118 Managing Faults on Avaya VSP 7200 Series and 8000 Series June 2015
Comments on this document? infodev@avaya.com










