Managing Faults on Avaya Virtual Services Platform 7200 Series and 8000 Series Version 4.2.1
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this release
- Chapter 3: Fault management fundamentals
- Chapter 4: Key Health Indicators using ACLI
- Chapter 5: Key Health Indicators using EDM
- Chapter 6: Link state change control using ACLI
- Chapter 7: Link state change control using EDM
- Chapter 8: RMON configuration using ACLI
- Chapter 9: RMON configuration using EDM
- Enabling RMON globally
- Enabling RMON on a port or VLAN
- Enabling RMON1 history
- Disabling RMON1 history
- Viewing RMON1 history statistics
- Creating an RMON1 alarm
- Creating an RMON1 port history alarm
- Viewing RMON1 alarms
- Deleting an RMON1 alarm
- Creating a default RMON1 event
- Creating a nondefault RMON1 event
- Viewing RMON1 events
- Viewing the RMON log
- Deleting an event
- Viewing the protocol directory
- Viewing the data source for protocol distribution statistics
- Viewing protocol distribution statistics
- Viewing the host interfaces enabled for monitoring
- Viewing address mappings
- Viewing the data source for host statistics
- Viewing network host statistics
- Viewing application host statistics
- Chapter 10: Viewing statistics using ACLI
- Chapter 11: Viewing statistics using EDM
- Chapter 12: Log and trap fundamentals
- Chapter 13: Log configuration using ACLI
- Chapter 14: Log configuration using EDM
- Chapter 15: SNMP trap configuration using ACLI
- Chapter 16: SNMP trap configuration using EDM
- Chapter 17: RMON alarm variables
- Glossary
Category Subcategory Variable Definition
generation is described in section
7.2.4.6 of the same document.
dot3StatsDeferredTransmissions A count of frames for which the
first transmission attempt on a
particular interface is delayed
because the medium is busy. The
count represented by an instance
of this object does not include
frames involved in collisions.
dot3StatsLateCollisions The number of times that a
collision is detected on a
particular interface later than 512
bit-times into the transmission of
a packet; 512 bit-times
corresponds to 51.2
microseconds on a 10 Mb/s
system. A (late) collision included
in a count represented by an
instance of this object is also
considered as a (generic)
collision for purposes of other
collision-related statistics.
dot3StatsExcessiveCollisions A count of frames where the
transmission on a particular
interface fails due to excessive
collisions.
dot3StatsInternalMacTransmitErrors A count of frames where the
transmission on a particular
interface fails due to an internal
MAC sublayer transmit error. A
frame is only counted by an
instance of this object if it is not
counted by the corresponding
instance of either the
dot3StatsLateCollisions object,
the dot3StatsExcessiveCollisions
object, or the
dot3StatsCarrierSenseErrors
object.
The precise meaning of the count
represented by an instance of this
object is implementation specific.
In particular, an instance of this
object can represent a count of
transmission errors on a
Table continues…
RMON alarm variables
June 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 113
Comments on this document? infodev@avaya.com










