Managing Faults on Avaya Virtual Services Platform 7200 Series and 8000 Series Version 4.2.1

CP1 [02/06/15 22:39:58.530:UTC] 0x00004595 00000000 GlobalRouter SNMP INFO Boot
ed with file
CP1 [02/06/15 22:39:59.547:UTC] 0x00004603 00400003.67108870 DYNAMIC CLEAR Glob
alRouter SNMP INFO 2k card up(CardNum=1 AdminStatus=1 OperStatus=1)
CP1 [02/06/15 22:39:59.547:UTC] 0x00004603 00400003.67108870 DYNAMIC CLEAR Glob
alRouter SNMP INFO 2k card up(CardNum=2 AdminStatus=1 OperStatus=1)
CP1 [02/06/15 22:39:59.547:UTC] 0x00004603 00400003.67108870 DYNAMIC CLEAR Glob
alRouter SNMP INFO 2k card up(CardNum=3 AdminStatus=1 OperStatus=1)
CP1 [02/06/15 22:40:45.839:UTC] 0x000045e5 00400005 DYNAMIC SET GlobalRouter SN
MP INFO Sending Cold-Start Trap
Variable definitions
Use the data in the following table to use the snmplog command.
Table 21: Variable definitions
Variable Value
enable Enables the logging of traps.
Use the command no snmplog enable to disable the
logging of traps.
Enabling SNMP trap logging
June 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 103
Comments on this document? [e-mail]