Installation Instructions

Parameter Specification
Maximum optical return loss tolerance 20 dB
Applicable cable plant
Maximum insertion loss, including connectors 2.6 dB (OM3) or 2.9 dB (OM4)
Minimum optical return loss 20 dB
Maximum link distance 80 m
Receiver characteristics
Maximum average receive power, each lane 4.3 dBm
Maximum input optical power Tolerates direct Tx to Rx connection
Stressed receiver sensitivity –5.0 dBm
40GBASE-ER4 QSFP+ specifications
The following table lists the transmitter and receiver specifications for the 40GBASE-ER4 QSFP+
transceiver with corresponding wavelengths. The reach for this QSFP+ transceiver is up to 40
kilometers. The part number is AA1404003-E6.
40GBASE-ER4 QSFP+
The cable plant must have a minimum of 9 dB insertion loss between the transmitter and receiver
for correct operation. If the fiber cable does not have this much loss, use an attenuator to meet the 9
dB requirement. No attenuator is needed if insertion loss is at least 9 dB.
Table 42: IEEE 802.3ae 40GBASE-ER4 QSFP+ specifications
Parameter
Specification
Distance Up to 40 kilometers
Loss budget 18.5 dB
Transmitter characteristics
Line rate 10 Gbps
Signaling rate, each lane 10GBASE 10.3125 Gbps
Lane wavelength ranges 1264.5 nanometers to 1277.5 nanometers
1284.5 nanometers to 1297.5 nanometers
1304.5 nanometers to 1317.5 nanometers
1324.5 nanometers to 1337.5 nanometers
Total average optical power 10.5 dBm
Average optical power,
each lane at 10.3125
Gbps
Min.
–2.7
Max.
4.5
Units
dBm
Difference in optical power between any two lanes 4.7 dB OMA
Minimum side mode suppression ratio 30 dBm
Table continues…
QSFP+
December 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 76
Comments on this document? [e-mail]