Installation Instructions

12. Serial number
13. 1D serial number barcode
General QSFP+ transceiver specifications
The following table describes general QSFP+ transceiver specifications.
Table 39: General QSFP+ specifications
Parameter Specification
Dimensions (H x W x D) 8.5 x 18.35 x 72.4 mm (0.33 x
0.72 x 2.85 in.), unless otherwise
stated.
Note:
The length of the pull tab
latch varies depending on the
vendor and the body, with a
length of 125 to 132 mm
(4.92 to 5.20 in.).
Connectors 40GBASE-SR4 4x10GBASE-SR
QSFP+
MPO or MTP
40GBASE-LR4 QSFP+ Duplex LC
40GBASE-LM4 QSFP+ Duplex LC
Storage temperature –40 °F (–4 °C) to 185 °F (85 °C)
Operating temperature 23 °F (−5 °C) to 158 °F (70 °C)
Supported QSFP+ transceivers
The following section provides specifications for supported QSFP+ transceivers.
40GBASE-SR4 QSFP+ specifications
The 40GBASE-SR4 4x10GBASE-SR transceiver provides a high-speed link at an aggregate
signaling rate.
Important:
Not all Avaya networking products support the 4x10GBASE-SR mode of operation.
The 40GBASE-SR4 transceiver supports the MPO connector. Typically, the MPO connector has two
alignment pins, which keeps the connector and the fibers aligned to the mating cable.
For more information about the 40GBASE-SR4 4x10GBASE-SR QSFP+ transceiver, including test
and measurement information, see the IEEE 802.3-2012 standard.
QSFP+
December 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 72
Comments on this document? [e-mail]