Installation Instructions

10GBASE-CX specifications
The 10GBASE-CX is a 2-pair twinaxial copper cable that plugs into the SFP+ socket and connects
two 10-gigabit ports. The reach for this cable is up to 15 m with a bit error rate (BER) better than
10
-12
.
The 10GBASE-CX is a lower cost alternative to the optical SFP+ devices.
For more information about the 10GBASE-CX, including test and measurement information and
more specifications, see the IEEE 802.3–2012 standard. The following table identifies the part
numbers for specific cable lengths.
Table 30: 10GBASE-CX cables
Cable length Part number
3 meter AA1403019-E6
5 meter AA1403020-E6
7 meter AA1403022-E6
10 meter AA1403018-E6
15 meter AA1403021-E6
10GBASE CWDM DDI SFP+ (40 km) specifications
The following table lists the part numbers of the 10GBASE CWDM DDI SFP+ (40 km) with
corresponding wavelengths.
Table 31: Part number and center wavelength assignment
Part number Center
wavelength
assignment
Reach Insertion loss
Tx to Rx
AA1403153-E6 1471 nm up to 40 km 5 dB
AA1403154-E6 1491 nm up to 40 km 5 dB
AA1403155-E6 1511 nm up to 40 km 5 dB
AA1403156-E6 1531 nm up to 40 km 5 dB
AA1403157-E6 1551 nm up to 40 km 5 dB
AA1403158-E6 1571 nm up to 40 km 5 dB
AA1403159-E6 1591 nm up to 40 km 5 dB
AA1403160-E6 1611 nm up to 40 km 5 dB
The following table lists the transmitter and receiver specifications for the 10GBASE CWDM DDI
SFP+ (40 km).
SFP+ specifications
December 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 59
Comments on this document? [e-mail]