Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this document
- Chapter 3: Hardware models
- Chapter 4: Preinstallation checklist
- Chapter 5: Installing the Avaya Virtual Services Platform 7200 Series
- Installation checklist
- Installation fundamentals
- Electrostatic discharge
- Technical specifications
- Package contents
- Installing a power supply
- Removing a power supply
- Installing a fan module
- LED state definitions
- Installing the switch in an equipment rack
- Cable requirements for the VSP 7200
- Installation and removal of transceivers
- Console port pin assignments
- 40GBASE-QSFP+ ports
- Software limitations
- Chapter 6: Translations of safety messages
6. Remove the two screws and nuts securing the short rear bracket to the rack rail. This
bracket is for 300mm-600mm equipment racks only and is not used in this installation. Save
the bracket for possible future use.
Installing the switch in an equipment rack
November 2016 Installing the Avaya VSP 7200 Series 65
Comments on this document? infodev@avaya.com