Installation Instructions
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this document
- Chapter 3: Hardware models
- Chapter 4: Preinstallation checklist
- Chapter 5: Installing the Avaya Virtual Services Platform 7200 Series
- Installation checklist
- Installation fundamentals
- Electrostatic discharge
- Technical specifications
- Package contents
- Installing a power supply
- Removing a power supply
- Installing a fan module
- LED state definitions
- Installing the switch in an equipment rack
- Cable requirements for the VSP 7200
- Installation and removal of transceivers
- Console port pin assignments
- 40GBASE-QSFP+ ports
- Software limitations
- Chapter 6: Translations of safety messages
• When a port on VSP 7254XSQ is disabled or enabled, or a cable replaced, or the switch
rebooted, the remote link can flap twice.
•
Avaya recommends enabling auto-negotiation to ensure proper operation at 100 Mbps speeds
on VSP 7254XTQ:
- Link instability will be seen if both ends are set to 100 Mbps auto-negotiation disabled and
you use a straight through cable.
- If Link instability is seen when you use a cross-over cable, a port disable or enable can fix
the issue.
For more information, see Installing Transceivers and Optical Components on VSP Operating
System Software, NN47227-301.
Hardware models
November 2016 Installing the Avaya VSP 7200 Series 18
Comments on this document? infodev@avaya.com