Admin Guide

Example
Enable power to Slot 1:
Switch:1 (config)# sys power slot 1
Disable power to Slot 1:
Switch:1 (config)# no sys power slot 1
Enable power to Slots 1 and 2:
Switch:1 (config)# sys power slot 1, 2
Disable power to Slots 1 and 2:
Switch:1 (config)# no sys power slot 1, 2
Variable definitions
Use the data in the following table to use the sys power slot command.
Variable Value
{slot[-slot][,...]} Identifies the slot in one of the following formats: a
single slot (1), a range of slots 1–3), or a series of
slots (1,2,4).
Chassis operations configuration using EDM
This section provides the details to configure basic hardware and system settings using Enterprise
Device Manager (EDM).
Editing system information
About this task
You can edit system information, such as the contact person, the name of the device, and the
location to identify the equipment.
Procedure
1. In the Device Physical View tab, select the Device.
2. In the navigation tree, open the following folders: Configuration > Edit.
3. Click Chassis.
4. Click the System tab.
5. Type the contact information in the sysContact field.
6. Type the system name in the sysName field.
Chassis operations
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 82
Comments on this document? [e-mail]