Admin Guide

4. To disable channelization on a port, enter:
no channelize [port {slot/port/sub-port[-slot/port/sub-port][,...]}]
enable
Example
Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# interface gigabitethernet 1/2
Switch:1(config-if)# channelize enable
Display the port status:
Switch:1(config)# show interfaces gigabitEthernet channelize 1/2-1/4
================================================================================
Port Channelization
================================================================================
--------------------------------------------------------------------------------
PORT ADMIN MODE CHANNEL TYPE
--------------------------------------------------------------------------------
1/2 true 40G
1/3 false 40G
1/4 false 40G
The following is an example of how to disable channelization on a port:
Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# interface gigabitethernet 1/2/1
Switch:1(config-if)# no channelize enable
Variable definitions
Use the data in following table to use the channelization command.
Variable
Value
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} Identifies the slot and port in one of the following
formats: a single slot and port (slot/port), a range of
slots and ports (slot/port-slot/port), or a series of
slots and ports (slot/port,slot/port,slot/port).If your
platform supports channelization for 40 Gbps ports
and the port is channelized, you must also specify
the sub-port in the format slot/port/sub-port.
Configuring serial management port dropping
Configure the serial management ports to drop a connection that is interrupted for any reason. If you
enable serial port dropping, the serial management ports drop the connection for the following
reasons:
• modem power failure
• link disconnection
• loss of the carrier
Chassis operations
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 80
Comments on this document? [e-mail]