Admin Guide

Variable Value
transceiver, the system applies
autonegotiation. If you install a 10 GbE
transceiver, the system does not remove the
autonegotiation settings from the configuration,
but the system simply ignores the configuration
because autonegotiation settings are irrelevant
to a 10 GbE transceiver. The system preserves
the saved configuration for autonegotiation
when resaved no matter which speed of
transceiver you install.
Enabling channelization
Enable channelization on 40 Gbps QSFP+ ports to configure them to operate as four 10 Gbps
Ethernet ports.
Note:
Enabling or disabling channelization resets the port QoS configuration to default values. For
information about configuring QoS values, see Configuring QoS and ACL-Based Traffic Filtering
on Avaya Virtual Services Platform 7200 Series and 8000 Series, NN47227-502.
Procedure
1. Enter GigabitEthernet Interface Configuration mode:
enable
configure terminal
interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-
port]][,...]}
Note:
If your platform supports channelization for 40 Gbps ports and the port is channelized,
you must also specify the sub-port in the format slot/port/sub-port.
2. Enable channelization on a port:
channelize [port {slot/port[-slot/port][,...]}] enable
3. Display the status of the ports:
show interfaces gigabitEthernet channelize [{slot/port[-slot/port]
[,...]}]
To display the details of the sub-ports, use:
show interfaces gigabitEthernet channelize detail [{slot/port/sub-
port[-slot/port/sub-port][,...]}]
Chassis operations configuration using ACLI
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 79
Comments on this document? [e-mail]