Admin Guide

interface gigabitethernet {slot/port[/sub-port][-slot/port[/sub-
port]][,...]}
4. Lock a port:
lock port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable
Example
Switch:1> enable
Switch:1# configure terminal
Log on to GigabitEthernet Interface Configuration mode:
Switch:1(config)# interface GigabitEthernet 1/1
Unlock port 1/14:
Switch:1(config-if)# no lock port 1/14 enable
Variable definitions
Use the data in the following table to use the interface gigabitethernet and lock port
commands.
Table 28: Variable definitions
Variable Value
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} Identifies the slot and port in one of the following
formats: a single slot and port (slot/port), a range of
slots and ports (slot/port-slot/port), or a series of
slots and ports (slot/port,slot/port,slot/port).If your
platform supports channelization for 40 Gbps ports
and the port is channelized, you must also specify
the sub-port in the format slot/port/sub-port.
For the lock port command, use the no form of
this command to unlock a port: no lock port
{slot/port[/sub-port][-slot/port[/sub-
port]][,...]}
Configuring SONMP
About this task
Configure the SynOptics Network Management Protocol (SONMP) to allow a network management
station (NMS) formulate a map that shows the interconnections between Layer 2 devices in a
network. The default status is enabled.
Procedure
1. Enter Global Configuration mode:
Chassis operations
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 72
Comments on this document? [e-mail]