Admin Guide
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this release
- Chapter 3: Basic administration
- Chapter 4: System startup fundamentals
- Chapter 5: Boot parameter configuration using ACLI
- Chapter 6: Run-time process management using ACLI
- Chapter 7: Chassis operations
- Chassis operations fundamentals
- Chassis operations configuration using ACLI
- Enabling jumbo frames
- Configuring port lock
- Configuring SONMP
- Viewing the topology message status
- Associating a port to a VRF instance
- Configuring an IP address for the management port
- Configuring Ethernet ports with Autonegotiation
- Enabling channelization
- Configuring serial management port dropping
- Controlling slot power
- Chassis operations configuration using EDM
- Editing system information
- Editing chassis information
- Configuring system flags
- Configuring channelization
- Configuring basic port parameters
- Viewing the boot configuration
- Configuring boot flags
- Enabling Jumbo frames
- Configuring the date and time
- Associating a port to a VRF instance
- Configuring CP Limit
- Configuring an IP address for the management port
- Editing the management port parameters
- Configuring the management port IPv6 interface parameters
- Configuring management port IPv6 addresses
- Auto reactivating the port of the SLPP shutdown
- Editing serial port parameters
- Enabling port lock
- Locking a port
- Viewing power information
- Viewing power status on VSP 8400
- Viewing fan information
- Viewing topology status information
- Viewing the topology message status
- Configuring a forced message control pattern
- Chapter 8: Hardware status using EDM
- Chapter 9: Domain Name Service
- Chapter 10: Licensing
- Chapter 11: Network Time Protocol
- Chapter 12: Secure Shell
- Chapter 13: System access
- System access fundamentals
- System access configuration using ACLI
- Enabling ACLI access levels
- Changing passwords
- Configuring an access policy
- Specifying a name for an access policy
- Allowing a network access to the switch
- Configuring access policies by MAC address
- System access security enhancements using ACLI
- Displaying the boot config flags status
- Enabling enhanced secure mode
- Creating accounts for different access levels
- Deleting accounts in enhanced secure mode
- Configuring a password for a specific user
- Returning the system to the factory defaults
- Configuring the password complexity rule
- Configuring the password length rule
- Configuring the change interval rule
- Configuring the reuse rule
- Configuring the maximum number of sessions
- Configuring the maximum age rule
- Configuring the pre- and post-notification rule
- System access configuration using EDM
- Chapter 14: ACLI show command reference
- Access, logon names, and passwords
- Basic switch configuration
- Current switch configuration
- CLI settings
- Ftp-access sessions
- Hardware information
- NTP server statistics
- Power summary
- Power information for power supplies
- System information
- System status (detailed)
- Telnet-access sessions
- Users logged on
- Port egress COS queue statistics
- CPU queue statistics
- Chapter 15: Port numbering and MAC address assignment reference
- Chapter 16: Supported standards, RFCs, and MIBs
- Glossary
Configuring boot flags...................................................................................................... 93
Enabling Jumbo frames................................................................................................... 94
Configuring the date and time........................................................................................... 95
Associating a port to a VRF instance................................................................................. 95
Configuring CP Limit........................................................................................................ 96
Configuring an IP address for the management port........................................................... 96
Editing the management port parameters.......................................................................... 98
Configuring the management port IPv6 interface parameters............................................ 100
Configuring management port IPv6 addresses................................................................. 101
Auto reactivating the port of the SLPP shutdown.............................................................. 102
Editing serial port parameters......................................................................................... 103
Enabling port lock.......................................................................................................... 103
Locking a port............................................................................................................... 104
Viewing power information............................................................................................. 104
Viewing power status on VSP 8400................................................................................ 105
Viewing fan information.................................................................................................. 106
Viewing topology status information................................................................................ 106
Viewing the topology message status............................................................................. 107
Configuring a forced message control pattern.................................................................. 108
Chapter 8: Hardware status using EDM.............................................................................. 109
Configuring polling intervals................................................................................................. 109
Viewing module information................................................................................................. 110
Viewing power supply parameters........................................................................................ 110
Viewing temperature on the chassis...................................................................................... 111
Chapter 9: Domain Name Service....................................................................................... 113
DNS fundamentals.............................................................................................................. 113
DNS configuration using ACLI.............................................................................................. 114
Configuring the DNS client............................................................................................. 114
Querying the DNS host.................................................................................................. 115
DNS configuration using EDM.............................................................................................. 116
Configuring the DNS client............................................................................................. 116
Querying the DNS host.................................................................................................. 117
Chapter 10: Licensing.......................................................................................................... 119
Licensing fundamentals....................................................................................................... 119
Feature licensing........................................................................................................... 119
License type and part numbers....................................................................................... 121
Feature license files....................................................................................................... 122
License installation using ACLI............................................................................................. 122
Installing a license file.................................................................................................... 122
Showing a license file.................................................................................................... 124
License installation using EDM............................................................................................. 125
Installing a license file.................................................................................................... 125
Chapter 11: Network Time Protocol.................................................................................... 127
Contents
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 6
Comments on this document? infodev@avaya.com










