Admin Guide

Variable Value
The default value is 9600. To configure this option to the default value, use
the default operator with the command.
Displaying the boot configuration
About this task
Display the configuration to view current or changed settings for the boot parameters.
Procedure
1. Enter Privileged EXEC mode:
enable
2. View the configuration:
show boot config <choice|flags|general|host|running-config
[verbose]|sio>
Example
Show the current boot configuration. (If you omit verbose, the system only displays the values that
you changed from their default value.):
Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1#(config)#show boot config running-config
#
#Thu Mar 20 15:12:01 2014 UTC
#
boot config flags ftpd
boot config flags rlogind
boot config flags sshd
boot config flags telnetd
boot config flags tftpd
no boot config flags verify-config
boot config choice primary backup-config-file "/intflash/config.cfg"
Variable definitions
Use the data in the following table to use the show boot config command.
Displaying the boot configuration
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 53
Comments on this document? [e-mail]