Admin Guide
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this release
- Chapter 3: Basic administration
- Chapter 4: System startup fundamentals
- Chapter 5: Boot parameter configuration using ACLI
- Chapter 6: Run-time process management using ACLI
- Chapter 7: Chassis operations
- Chassis operations fundamentals
- Chassis operations configuration using ACLI
- Enabling jumbo frames
- Configuring port lock
- Configuring SONMP
- Viewing the topology message status
- Associating a port to a VRF instance
- Configuring an IP address for the management port
- Configuring Ethernet ports with Autonegotiation
- Enabling channelization
- Configuring serial management port dropping
- Controlling slot power
- Chassis operations configuration using EDM
- Editing system information
- Editing chassis information
- Configuring system flags
- Configuring channelization
- Configuring basic port parameters
- Viewing the boot configuration
- Configuring boot flags
- Enabling Jumbo frames
- Configuring the date and time
- Associating a port to a VRF instance
- Configuring CP Limit
- Configuring an IP address for the management port
- Editing the management port parameters
- Configuring the management port IPv6 interface parameters
- Configuring management port IPv6 addresses
- Auto reactivating the port of the SLPP shutdown
- Editing serial port parameters
- Enabling port lock
- Locking a port
- Viewing power information
- Viewing power status on VSP 8400
- Viewing fan information
- Viewing topology status information
- Viewing the topology message status
- Configuring a forced message control pattern
- Chapter 8: Hardware status using EDM
- Chapter 9: Domain Name Service
- Chapter 10: Licensing
- Chapter 11: Network Time Protocol
- Chapter 12: Secure Shell
- Chapter 13: System access
- System access fundamentals
- System access configuration using ACLI
- Enabling ACLI access levels
- Changing passwords
- Configuring an access policy
- Specifying a name for an access policy
- Allowing a network access to the switch
- Configuring access policies by MAC address
- System access security enhancements using ACLI
- Displaying the boot config flags status
- Enabling enhanced secure mode
- Creating accounts for different access levels
- Deleting accounts in enhanced secure mode
- Configuring a password for a specific user
- Returning the system to the factory defaults
- Configuring the password complexity rule
- Configuring the password length rule
- Configuring the change interval rule
- Configuring the reuse rule
- Configuring the maximum number of sessions
- Configuring the maximum age rule
- Configuring the pre- and post-notification rule
- System access configuration using EDM
- Chapter 14: ACLI show command reference
- Access, logon names, and passwords
- Basic switch configuration
- Current switch configuration
- CLI settings
- Ftp-access sessions
- Hardware information
- NTP server statistics
- Power summary
- Power information for power supplies
- System information
- System status (detailed)
- Telnet-access sessions
- Users logged on
- Port egress COS queue statistics
- CPU queue statistics
- Chapter 15: Port numbering and MAC address assignment reference
- Chapter 16: Supported standards, RFCs, and MIBs
- Glossary
Request for comment Description
RFC 4862 IPv6 stateless address autoconfiguration
RFC 6329 IS-IS Extensions supporting Shortest Path Bridging
Quality of service
Table 55: Supported request for comments
Request for comment Description
RFC2474 and RFC2475 DiffServ Support
RFC2597 Assured Forwarding PHB Group
RFC2598 An Expedited Forwarding PHB
Network management
Table 56: Supported request for comments
Request for comment Description
RFC1155 SMI
RFC1157 SNMP
RFC1215 Convention for defining traps for use with the SNMP
RFC1271 Remote Network Monitoring Management
Information Base
RFC1305 Network Time Protocol v3 Specification,
Implementation and Analysis3
RFC1350 The TFTP Protocol (Revision 2)
RFC1354 IP Forwarding Table MIB
RFC1757 Remote Network Monitoring Management
Information Base
RFC1907 Management Information Base for Version 2 of the
Simple Network Management Protocol (SNMPv2)
RFC1908 Coexistence between v1 & v2 of the Internet-
standard Network Management Framework
RFC1930 Guidelines for creation, selection, and registration of
an Autonomous System (AS)
RFC2428 FTP Extensions for IPv6
Table continues…
Supported standards, RFCs, and MIBs
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 224
Comments on this document? infodev@avaya.com