Admin Guide
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this release
- Chapter 3: Basic administration
- Chapter 4: System startup fundamentals
- Chapter 5: Boot parameter configuration using ACLI
- Chapter 6: Run-time process management using ACLI
- Chapter 7: Chassis operations
- Chassis operations fundamentals
- Chassis operations configuration using ACLI
- Enabling jumbo frames
- Configuring port lock
- Configuring SONMP
- Viewing the topology message status
- Associating a port to a VRF instance
- Configuring an IP address for the management port
- Configuring Ethernet ports with Autonegotiation
- Enabling channelization
- Configuring serial management port dropping
- Controlling slot power
- Chassis operations configuration using EDM
- Editing system information
- Editing chassis information
- Configuring system flags
- Configuring channelization
- Configuring basic port parameters
- Viewing the boot configuration
- Configuring boot flags
- Enabling Jumbo frames
- Configuring the date and time
- Associating a port to a VRF instance
- Configuring CP Limit
- Configuring an IP address for the management port
- Editing the management port parameters
- Configuring the management port IPv6 interface parameters
- Configuring management port IPv6 addresses
- Auto reactivating the port of the SLPP shutdown
- Editing serial port parameters
- Enabling port lock
- Locking a port
- Viewing power information
- Viewing power status on VSP 8400
- Viewing fan information
- Viewing topology status information
- Viewing the topology message status
- Configuring a forced message control pattern
- Chapter 8: Hardware status using EDM
- Chapter 9: Domain Name Service
- Chapter 10: Licensing
- Chapter 11: Network Time Protocol
- Chapter 12: Secure Shell
- Chapter 13: System access
- System access fundamentals
- System access configuration using ACLI
- Enabling ACLI access levels
- Changing passwords
- Configuring an access policy
- Specifying a name for an access policy
- Allowing a network access to the switch
- Configuring access policies by MAC address
- System access security enhancements using ACLI
- Displaying the boot config flags status
- Enabling enhanced secure mode
- Creating accounts for different access levels
- Deleting accounts in enhanced secure mode
- Configuring a password for a specific user
- Returning the system to the factory defaults
- Configuring the password complexity rule
- Configuring the password length rule
- Configuring the change interval rule
- Configuring the reuse rule
- Configuring the maximum number of sessions
- Configuring the maximum age rule
- Configuring the pre- and post-notification rule
- System access configuration using EDM
- Chapter 14: ACLI show command reference
- Access, logon names, and passwords
- Basic switch configuration
- Current switch configuration
- CLI settings
- Ftp-access sessions
- Hardware information
- NTP server statistics
- Power summary
- Power information for power supplies
- System information
- System status (detailed)
- Telnet-access sessions
- Users logged on
- Port egress COS queue statistics
- CPU queue statistics
- Chapter 15: Port numbering and MAC address assignment reference
- Chapter 16: Supported standards, RFCs, and MIBs
- Glossary
Request for comment Description
RFC 2464 Transmission of IPv6 packets over Ethernet
networks
RFC 2548 Microsoft vendor specific RADIUS attributes
RFC 2616 Hypertext Transfer Protocol 1.1
RFC 2710 and RFC 3810 MLD (host-mode only)
RFC 2716 PPP EAP Transport Level Security (TLS)
Authentication Protocol
RFC 2740 OSPFv3
RFC 2819 RMON
RFC 2865 RADIUS
RFC 2874 DNS Extensions for IPv6
RFC 2992 Analysis of an Equal-Cost Multi-Path Algorithm
RFC 3046 DHCP Option 82
RFC 3162 IPv6 RADIUS client
RFC 3315 IPv6 DHCP Relay
RFC 3376 IGMPv3
RFC 3411 and RFC 2418 SNMP over IPv6 networks
RFC 3513 Internet Protocol Version 6 (IPv6) Addressing
Architecture
RFC 3569 An overview of Source-Specific Multicast (SSM)
RFC 3587 IPv6 Global Unicast Address Format
RFC3748 Extensible Authentication Protocol
RFC 3768 and draft-ietf-vrrp-ipv6-spec-08.txt IPv6 capable VRRP
RFC 4213 IPv6 configured tunnel
RFC 4250–RFC 4256 SSH server and client support
RFC 4301 Security Architecture for IPv6
RFC 4302 IP Authentication Header (AH)
RFC 4303 IP Encapsulated Security Payload (ESP)
RFC 4305 Cryptographic algorithm implementation
requirements for ESP and AH
RFC 4308 Cryptographic suites for Internet Protocol Security
(IPsec)
RFC 4552 OSPFv3 Authentication and confidentiality for
OSPFv3
RFC 4835 Cryptographic algorithm implementation for ESP and
AH
RFC 4861 IPv6 Neighbor discovery
Table continues…
Supported RFCs
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 223
Comments on this document? infodev@avaya.com