Admin Guide

max-msg-num : 5
status : disable
The following example shows output from the show sys setting command.
Switch:1#show sys setting
udp-checksum : enable
mroute-stream-limit : disable
contact : http://support.avaya.com/
location : 211 Mt. Airy Road,Basking Ridge,NJ 07920
name : VSP-8284XSQ
portlock : off
sendAuthenticationTrap : false
autotopology : on
ForceTopologyIpFlag : false
clipId-topology-ip : 0
mtu : 1950
data-path-fault-shutdown : enable
The following example shows output from the show sys software command.
Switch:1#show sys software
System Software Info :
Default Runtime Config File : /intflash/rich.cfg
Config File :
Last Runtime Config Save : Thu Mar 20 05:50:13 2014
Boot Config Table
Version : Build vsp6k_4.0.0.0_GA (PRIVATE) on Sat Mar 15 13:06:52 EDT 2014
PrimaryConfigSource : /intflash/rich.cfg
SecondaryConfigSource : /intflash/config.cfg
EnableFactoryDefaults : false
EnableDebugMode : false
EnableHwWatchDogTimer : false
EnableRebootOnError : true
EnableTelnetServer : true
EnableRloginServer : false
EnableFtpServer : true
EnableTftpServer : false
System status (detailed)
Use the show tech command to display technical information about system status and information
about the hardware, software, and operation of the switch.
The information available from the show tech command includes general information about the
system (such as location), hardware (chassis, power supplies, fans, and ports), system errors, boot
configuration, software versions, memory, port information (locking status, configurations, names,
interface status), VLANs and STGs (numbers, port members), Virtual Router Redundancy Protocol
(VRRP), and log and trace files. This command displays more information than the similar show
sys-info command. The syntax for this command is as follows.
show tech
System status (detailed)
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 211
Comments on this document? [e-mail]