Admin Guide

Note:
The save config command saves the configuration file with the filename configured
as the primary configuration filename in boot config. Use the command show boot
config choice to view the current primary and backup configuration filenames.
Example
Configure the change interval rule to 72 hours:
Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#password change-interval 72
Switch:1(config)#save config
Variable definitions
Use the data in the following table to use the password change-interval command.
Variable Value
<1–999> Configures the minimum interval between
consecutive password changes. The default is 24
hours.
Configuring the reuse rule
Use the following procedure to configure the password reuse rule. The default password reuse rule
is 3.
Before you begin
• Enable enhanced secure mode.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Configure the password reuse rule option:
password password-history <3–32>
3. (Optional) Configure the password reuse rule to the default:
default password password-history
4. Save the configuration:
save config
Note:
The save config command saves the configuration file with the filename configured
as the primary configuration filename in boot config. Use the command show boot
config choice to view the current primary and backup configuration filenames.
System access configuration using ACLI
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 189
Comments on this document? [e-mail]