Admin Guide

save config
Note:
The save config command saves the configuration file with the filename configured
as the primary configuration filename in boot config. Use the command show boot
config choice to view the current primary and backup configuration filenames.
Example
Configure the password complexity rule to require two uppercase, two lowercase, two numeric and
two special characters in each password:
Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#password password–rule 2 2 2 2
Switch:1(config)#save config
Variable definitions
Use the data in the following table to use the password password-rule command.
Variable Value
<1–2> <1–2> <1–2> <1–2> Configures the minimum password rule. The first
variable defines the number of uppercase characters
required. The second <1-2> variable defines the
number of lowercase characters required. The third
<1-2> variable defines the number of numeric
characters required. The fourth <1-2> variable
defines the number of special characters required.
The default for each of these is 2.
Configuring the password length rule
About this task
Configure the password length rule after you enable enhanced secure mode. By default, the
minimum password length is 15.
Before you begin
• Enable enhanced secure mode.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Configure the password length rule option:
password min-passwd-len <8–32>
3. (Optional) Configure the password length rule to the default:
default password min-passwd-len
System access configuration using ACLI
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 187
Comments on this document? [e-mail]