Admin Guide

configure terminal
2. Return the system to the factory defaults:
sys system-default
3. Restart the switch:
reset
4. Save the configuration:
save config
Example
Return the system to the factory defaults:
Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#sys system-default
WARNING: Executing this command returns the system to factory defaults and deletes all
local configured user accounts.
This command needs system reset to take into effect
Do you want to continue (y/n) ? y
Switch:1#reset
The device reboots and the Admin user logs into the system again.
Switch:1(config)#save config
Configuring the password complexity rule
About this task
Use the following procedure to configure the password complexity rule.
The password complexity rule default is to use at least two uppercase, two lowercase, two numeric,
and two special character to meet the password criteria.
Before you begin
• You must enable enhanced secure mode.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Configure the password complexity rule:
password password–rule <1–2> <1–2> <1–2> <1–2>
3. (Optional) Configure the password complexity rule to the default:
default password password–rule
4. Save the configuration:
System access
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 186
Comments on this document? [e-mail]