Admin Guide

Table 47: Variable definitions
Variable Value
name WORD<0–15> Specifies a name expressed as a string from 0–15
characters.
Allowing a network access to the switch
About this task
Specify the network to which you want to allow access.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Specify the network:
access-policy <1-65535> [mode <allow|deny>] [network <A.B.C.D>
<A.B.C.D>]
Example
Switch:1> enable
Switch:1# configure terminal
Specify the network to which you want to allow access:
Switch:1(config)# access-policy 5 mode allow network 192.192.192.0 24
Variable definitions
Use the data in the following table to use the access-policy command.
Table 48: Variable definitions
Variable Value
mode <allow|deny> Specifies whether a designated network address is
allowed or denied access through the specified
access service. The default is allow.
network <A.B.C.D> <A.B.C.D> The IPv4 address and subnet mask, or the IPv6
address and prefix-length permitted, or denied,
access through the specified access service.
System access configuration using ACLI
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 179
Comments on this document? [e-mail]