Admin Guide

Variable Value
password-history <3-32> Specifies the number of previous passwords the
switch stores. You cannot reuse a password that is
stored in the password history. The default is 3.
To configure this option to the default value, use the
default operator with the command.
Configuring an access policy
About this task
Configure an access policy to control access to the switch.
You can permit network stations to access the switch or forbid network stations to access the
switch.
For each service, you can also specify the level of access; for example, read-only or read-write-all.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Create an access policy by assigning it a number:
access-policy <1-65535>
3. Restrict the access to a specific level:
access-policy <1-65535> access-strict
4. Configure access for an access policy:
access-policy <1-65535> accesslevel <ro|rwa|rw>
5. Configure the access policy mode, network, and precedence:
access-policy <1-65535> [mode <allow|deny>] [precedence <1-128>]
[network <A.B.C.D> <A.B.C.D>]
If you configure the access policy mode to deny, the system checks the mode and service,
and if they match the system denies the connection. With the access policy mode configured
to deny, the system does not check accesslevel and access-strict information. If you
configure the access policy mode to allow, the system continues to check the accesslevel
and access-strict information.
6. Configure optional access protocols for an access policy:
access-policy <1-65535> [ftp] [http] [ssh] [telnet] [tftp]
7. Configure optional trusted username access for an access policy:
System access configuration using ACLI
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 175
Comments on this document? [e-mail]