Admin Guide

Variable definitions
Use the data in the following table to use the cli password command.
Table 45: Variable definitions
Variable Value
layer1|layer2|layer3|read-only|read-write|read-write-
all
Changes the password for the specific access level.
WORD<1–20> Specifies the user logon name.
Use the data in the following table to use the password command.
Table 46: Variable definitions
Variable Value
access level WORD<2–8> Permits or blocks this access level. The available
access level values are as follows:
• l1
• l2
• l3
• ro
• rw
• rwa
aging-time <1-365> Configures the expiration period for passwords in
days, from 1–365. The default is 90 days.
default-lockout-time <60-65000> Changes the default lockout time after three invalid
attempts. Configures the lockout time, in seconds,
and is in the 60–65000 range. The default is 60
seconds.
To configure this option to the default value, use the
default operator with the command.
lockout WORD<0–46> time <60-65000> Configures the host lockout time.
• WORD<0–46> is the host IP address in the format
a.b.c.d.
• <60-65000> is the lockout-out time, in seconds, in
the 60–65000 range. The default is 60 seconds.
min-passwd-len <10-20> Configures the minimum length for passwords in
high-secure mode. The default is 10 characters.
To configure this option to the default value, use the
default operator with the command.
Table continues…
System access
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 174
Comments on this document? [e-mail]