Admin Guide

Variable Value
secure Enables SSH in secure mode and immediately disables the access
services SNMP, FTP, TFTP, rlogin, and Telnet. The default is disabled.
Use the no operator before this parameter, no ssh secure, to disable
SSH in secure mode.
timeout <1-120> Specifies the SSH connection authentication timeout in seconds. Default is
60 seconds.
version <v2only> Configures the SSH version. The default is v2only.
The switch only supports SSHv2.
Verifying and displaying SSH configuration information
Verify that SSH services are enabled on the VSP switch and display SSH configuration information
to ensure that the SSH parameters are properly configured.
Procedure
1. Log on to the switch to enter User EXEC mode.
2. Verify that SSH services are enabled and view the SSH configuration:
show ssh <global|session>
Example
Display global system SSH information:
Switch:1(config)#show ssh global
Total Active Sessions : 0
version : v2only
port : 22
max-sessions : 4
timeout : 60
action rsa-keygen : rsa-keysize 2048
action dsa-keygen : dsa-keysize 1024
rsa-auth : true
dsa-auth : true
pass-auth : false
enable : true
Variable definitions
Use the data in the following table to use the show ssh command.
Table 41: Variable definitions
Variable Value
global Display global system SSH information.
session Display the current session SSH information.
Secure Shell configuration using ACLI
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 155
Comments on this document? [e-mail]