Admin Guide

Important:
The license filename stored on a device must meet the following requirements:
• Maximum of 63 alphanumeric characters
• No spaces or special characters allowed
• Underscore (_) is allowed
• The file extension ".xml" is required
Example
Use FTP to transfer a license file from a PC to the internal flash on the device:
C:\Users\jsmith>ftp 192.0.2.16
Connected to 192.0.2.16 (192.0.2.16).
220 FTP server ready
Name (192.0.2.16:(none)): rwa
331 Password required
Password:
230 User logged in
ftp> bin
200 Type set to I, binary mode
ftp> put premier_macsec.xml /intflash/premier_macsec.xml
local: premier_macsec.xml remote: /intflash/premier_macsec.xml
227 Entering Passive Mode (192,0,2,16,4,2)
150 Opening BINARY mode data connection
226 Transfer complete
101 bytes sent in 2.7e-05 secs (3740.74 Kbytes/sec)
ftp>
Log in to the device and load the license. The following example shows a successful operation.
Switch:1(config)#load-license
Switch:1(config)#CP1 [06/12/15 15:59:57.636:UTC] 0x000005bc 00000000 GlobalRouter SW INFO
License Successfully Loaded From </intflash/premier_macsec.xml> License Type -- PREMIER
+MACSEC
The following example shows an unsuccessful operation.
Switch:1(config)#load-license
Switch:1(config)#CP1 [06/12/15 15:58:48.376:UTC] 0x000006b9 00000000 GlobalRouter SW
INFO Invalid license file /intflash/license_VSP_8000_example.xml HostId is not Valid
CP1 [06/12/15 15:58:48.379:UTC] 0x000005c4 00000000 GlobalRouter SW INFO No Valid
License found.
Variable definitions
Use the data in the following table to help you install a license with the copy command.
Variable Value
<a.b.c.d> Specifies the IPv4 and IPv6 address of the TFTP server from which to
copy the license file.
Table continues…
License installation using ACLI
October 2015 Administering Avaya VSP 7200 Series and 8000 Series 123
Comments on this document? [e-mail]