Installation Instructions

Part number Center wavelength
assignment
Reach Minimum insertion loss
Tx and Rx
AA1403162-E6 1491 nm 70 km 10 dB
AA1403163-E6 1511 nm 70 km 10 dB
AA1403164-E6 1531 nm 70 km 10 dB
AA1403165-E6 1551 nm 70 km 10 dB
AA1403166-E6 1571 nm 70 km 10 dB
AA1403167-E6 1591 nm 70 km 10 dB
AA1403168-E6 1611 nm 70 km 10 dB
The following table lists the transmitter and receiver specifications for the 10GBASE-ZR CWDM DDI
SFP+ transceiver.
Table 35: 10GBASE-ZR CWDM DDI SFP+ specifications
Parameter Specifications
Transmitter characteristics
Optical Data Rate (nominal) 9.95 Gbps to 10.313 Gbps
Center wavelength Nominal –6.5 nm to nominal +6.5 nm
Spectral width (RMS at –20 dB) 1 nm
RIN OMA –128 dB/Hz
Extinction ratio (minimum) 8.2 dB
Tx output: Min Max Units
P_avg –1 4 dBm
OMA +0.7 — dBm
OMA-TDP –2.3 — dBm
TDP at 1400 ps dispersion 3 dB
Optical return loss tolerance 21 dB
Receiver characteristics
Wavelength range 1460 nm to 1620 nm
Rx sensitivity: Min Max Units
back-to-back — –23 dBm
with 70 km fiber — –21 dBm
with 70 km fiber, OMA — –19.3 dBm
Receiver overload –7 dBm, P_avg
Receiver reflectance –27 dB
Receiver damage threshold +5 dBm, P_avg
* Achievable link distance is primarily dependent on cable plant insertion loss. 70 km is not possible
in some situations.
SFP+ specifications
April 2016 Installing Transceivers and Optical Components on Avaya VSP Operating System
Software 63
Comments on this document? [e-mail]