Admin Guide

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-
port]][,...]}
Note:
If your platform supports channelization for 40 Gbps ports and the port is channelized,
you must also specify the sub-port in the format slot/port/sub-port.
2. Enable channelization on a port:
channelize [port {slot/port[-slot/port][,...]}] enable
3. Display the status of the ports:
show interfaces gigabitEthernet channelize [{slot/port[-slot/port]
[,...]}]
To display the details of the sub-ports, use:
show interfaces gigabitEthernet channelize detail [{slot/port/sub-
port[-slot/port/sub-port][,...]}]
4. To disable channelization on a port, enter:
no channelize [port {slot/port/sub-port[-slot/port/sub-port][,...]}]
enable
Example
Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# interface gigabitethernet 1/2
Switch:1(config-if)# channelize enable
Display the port status:
Switch:1(config)# show interfaces gigabitEthernet channelize 1/2-1/4
================================================================================
Port Channelization
================================================================================
--------------------------------------------------------------------------------
PORT ADMIN MODE CHANNEL TYPE
--------------------------------------------------------------------------------
1/2 true 40G
1/3 false 40G
1/4 false 40G
The following is an example of how to disable channelization on a port:
Switch:1> enable
Switch:1# configure terminal
Switch:1(config)# interface gigabitethernet 1/2/1
Switch:1(config-if)# no channelize enable
Variable definitions
Use the data in following table to use the channelization command.
Chassis operations
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 82
Comments on this document? [e-mail]