Admin Guide

Configuring port lock
About this task
Configure port lock to administratively lock a port or ports to prevent other users from changing port
parameters or modifying port action. You cannot modify a locked port until you unlock the port.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Enable port lock globally:
portlock enable
3. Log on to GigabitEthernet Interface Configuration mode:
interface gigabitethernet {slot/port[/sub-port][-slot/port[/sub-
port]][,...]}
4. Lock a port:
lock port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable
Example
Switch:1> enable
Switch:1# configure terminal
Log on to GigabitEthernet Interface Configuration mode:
Switch:1(config)# interface GigabitEthernet 1/1
Unlock port 1/14:
Switch:1(config-if)# no lock port 1/14 enable
Variable definitions
Use the data in the following table to use the interface gigabitethernet and lock port
commands.
Table 29: Variable definitions
Variable Value
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} Identifies the slot and port in one of the following
formats: a single slot and port (slot/port), a range of
slots and ports (slot/port-slot/port), or a series of
slots and ports (slot/port,slot/port,slot/port). If your
platform supports channelization for 40 Gbps ports
Chassis operations
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 74
Comments on this document? [e-mail]