Admin Guide

Variable Value
spanning tree mode, you must save the current
configuration and restart the switch.
spbm-config-mode Enables you to configure SPB and IS-IS, but you
cannot configure PIM and IGMP either globally or on
an interface.
Use the no operator so that you can configure PIM
and IGMP.
The boot flag is enabled by default. To set this flag
to the default value, use the default operator with the
command.
sshd Activates or disables the SSHv2 server service. The
default value is disabled.
telnetd Activates or disables the Telnet server service. The
default is disabled.
tftpd Activates or disables Trivial File Transfer Protocol
server service. The default value is disabled.
trace-logging Activates or disables the creation of trace logs. The
default value is disabled.
Important:
Do not change this parameter unless directed
by Avaya.
verify-config Activates syntax checking of the configuration file.
The default is enabled.
• Primary config behavior: When the verifyconfig flag
is enabled, the primary config file is pre-checked
for syntax errors. If the system finds an error, the
primary config file is not loaded, instead the
system loads the backup config file.
If the verify-config flag is disabled, the system
does not pre-check syntax errors. When the verify-
config flag is disabled, the system ignores any
lines with errors during loading of the primary
config file. If the primary config file is not present or
cannot be found, the system tries to load the
backup file.
• Backup config behavior: If the system loads the
backup config file, the system does not check the
backup file for syntax errors. It does not matter if
the verify-config flag is disabled or enabled. With
the backup config file, the system ignores any lines
with errors during the loading of the backup config
file.
Table continues…
Enabling remote access services
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 45
Comments on this document? [e-mail]