Admin Guide

Resetting system functions
About this task
Reset system functions to reset all statistics counters, the console port (10101).
Procedure
1. Enter Privileged EXEC mode:
enable
2. Reset system functions:
sys action reset {console|counters}
Example
Switch:1> enable
Reset the statistics counters:
Switch:1> sys action reset counters
Are you sure you want to reset system counters (y/n)? y
Variable definitions
Use the data in the following table to use the sys action command.
Table 4: Variable definitions
Variable Value
reset {console|counters} Reinitializes the hardware universal asynchronous receiver
transmitter (UART) drivers. Use this command only if the console
connection does not respond. Resets all the statistics counters in the
switch to zero. Resets the console port.
Sourcing a configuration
About this task
The source cli command is intended for use with a switch that is running with a factory default
configuration to quick load a pre-existing configuration from a file. If you source a configuration file to
merge that configuration into a running configuration, it can result in operational configuration loss if
the sourced configuration file contains any configuration that has dependencies on or conflicts with
the running configuration.
Procedure
1. Enter Privileged EXEC mode:
enable
Basic administration
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 26
Comments on this document? [e-mail]