Admin Guide

The syntax for this command is as follows.
show sys power power-supply
The following example shows sample command output.
VSP-8284XSQ:1#show sys power power-supply
================================================================================
Power Supply Information
================================================================================
Power Type Input Serial Part Oper Max
Supply Voltage Num Num Status Power
--------------------------------------------------------------------------------
PS#2 AC 110/220 GWXD1349000116- DPS-800RB up 800
--------------------------------------------------------------------------------
System information
Use the show sys command to display system status and technical information about the switch
hardware components and software configuration. The command shows several pages of
information, including general information about the system (such as location), chassis (type, serial
number, and base MAC address), temperature, power supplies, fans, cards, system errors, port
locks, topology status, and message control information. The syntax for this command is as follows.
show sys <dns|force-msg|mgid-usage|msg-control|mtu|power|setting|
software|stats|topology-ip>
The following table explains parameters for this command.
Table 52: Command parameters
Parameter
Description
dns
Shows the DNS default domain name.
force-msg
Shows the message control force message pattern
settings.
mgid-usage
Shows the multicast group ID (MGID) usage for VLANs
and multicast traffic.
msg-control
Shows the system message control function status
(activated or disabled).
mtu
Shows system maximum transmission unit (MTU)
information.
power
Shows power information for the chassis. Command
options are
• power-supply—power information for each power
supply
• slot—power information for each slot
Table continues…
System information
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 227
Comments on this document? [e-mail]