Admin Guide

Chapter 14: ACLI show command reference
This reference information provides show commands to view the operational status of the switch.
Access, logon names, and passwords
Use the show cli password command to display the access, logon name, and password
combinations. The syntax for this command is as follows.
show cli password
The following example shows output from the show cli password command.
Switch:1#show cli password
access-level
aging 90
min-passwd-len 10
password-history 3
ACCESS LOGIN STATE
rwa rwa NA
rw rw ena
l3 l3 ena
l2 l2 ena
l1 l1 ena
ro ro ena
Default Lockout Time 60
Lockout-Time:
IP Time
The following example shows output from the show cli password command if enhanced secure
mode is enabled.
Note:
After you enable enhanced secure mode, the parameters in the output for the show cli
password command apply to all of the role-based users, except for the admin user. So for
instance, the system mandates that the admin user must have a password length of 15, and a
password with two of each of the following characters: uppercase, lowercase, numeric and
special character. However, the admin user can then configure this differently for the other user
access levels. The following values that display for min-passwd-len and password-rule are
those configured by admin, and they apply to the privilege, operator, security, and auditor
access levels.
Switch:1#show cli password
change-interval 24
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 218
Comments on this document? [e-mail]