Admin Guide

Variable definitions
Use the data in the following table to use the password create-user command.
Variable Value
{auditor|operator|privilege|security} Specifies the access level for the user.
WORD<1–255> Specifies the user name.
Deleting accounts in enhanced secure mode
Use the following procedure to delete accounts in enhanced secure mode.
Before you begin
• You must enable enhanced secure mode in either the JITC or non-JITC sub-modes. It is
recommended that you use the non-JITC sub-mode because the JITC sub-mode is more
restrictive and prevents the use of some troubleshooting utilities.
• You must be an admin or privilege user to delete accounts.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Delete an account on the switch:
password delete–user username WORD<1–255>
3. Save the configuration:
save config
Note:
The save config command saves the configuration file with the filename configured
as the primary configuration filename in boot config. Use the command show boot
config choice to view the current primary and backup configuration filenames.
Example
Delete an account for jsmith:
Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#password delete-user user-name jsmith
Switch:1(config)#save config
Variable definitions
Use the data in the following table to use the password delete-user command.
Variable
Value
user-name WORD<1–255> Specifies the user name.
System access
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 200
Comments on this document? [e-mail]