Admin Guide

Variable Value
aging-time <1-365> Configures the expiration period for passwords in
days, from 1–365. The default is 90 days.
default-lockout-time <60-65000> Changes the default lockout time after three invalid
attempts. Configures the lockout time, in seconds,
and is in the 60–65000 range. The default is 60
seconds.
To configure this option to the default value, use the
default operator with the command.
lockout WORD<0–46> time <60-65000> Configures the host lockout time.
• WORD<0–46> is the host IP address in the format
a.b.c.d.
• <60-65000> is the lockout-out time, in seconds, in
the 60–65000 range. The default is 60 seconds.
min-passwd-len <10-20> Configures the minimum length for passwords in
high-secure mode. The default is 10 characters.
To configure this option to the default value, use the
default operator with the command.
password-history <3-32> Specifies the number of previous passwords the
switch stores. You cannot reuse a password that is
stored in the password history. The default is 3.
To configure this option to the default value, use the
default operator with the command.
Configuring an access policy
About this task
Configure an access policy to control access to the switch.
You can permit network stations to access the switch or forbid network stations to access the
switch.
For each service, you can also specify the level of access; for example, read-only or read-write-all.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Create an access policy by assigning it a number:
access-policy <1-65535>
3. Restrict the access to a specific level:
System access
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 190
Comments on this document? [e-mail]