Admin Guide

Associating a port to a VRF instance
About this task
Associate a port to a Virtual Router Forwarding (VRF) instance so that the port becomes a member
of the VRF instance.
You can assign a VRF instance to a port after you configure the VRF. The system assigns ports to
the GlobalRouter, VRF 0, by default.
Procedure
1. In the Device Physical View tab, select a port.
2. In the navigation tree, open the following folders: Configuration > Edit > Port.
3. Click General.
4. Click the VRF tab.
5. To the right of the BrouterVrfId box, click the ellipsis (...) button.
6. In the BrouterVrfId dialog box, select the required VRF.
7. Click OK.
8. Click Apply.
Configuring CP Limit
Configure CP Limit functionality to protect the switch from becoming congested by an excess of data
flowing through one or more ports.
Procedure
1. In the Device Physical View tab, select a port.
2. In the navigation tree, open the following folders: Configuration > Edit > Port.
3. Click General.
4. Click the CP Limit tab.
5. Select the AutoRecoverPort check box.
6. Click Apply.
CP Limit field descriptions
Use the data in the following table to use the CP Limit tab.
Chassis operations
January 2017 Administering Avaya VSP 7200 Series and 8000 Series 100
Comments on this document? [e-mail]