Installation Instructions

10GBASE CWDM DDI SFP+ (70 km) specifications
The following table lists the part numbers for the 10GBASE CWDM DDI SFP+ (70 km) transceivers
with corresponding wavelengths.
The reach for this SFP+ transceiver is up to 70 km* at a wavelength of 1551 nm.
Table 29: Part number and center wavelength assignment
Part number Center wavelength
assignment
Reach Minimum insertion loss
Tx and Rx
AA1403161-E6 1471 nm 70 km 10 dB
AA1403162-E6 1491 nm 70 km 10 dB
AA1403163-E6 1511 nm 70 km 10 dB
AA1403164-E6 1531 nm 70 km 10 dB
AA1403165-E6 1551 nm 70 km 10 dB
AA1403166-E6 1571 nm 70 km 10 dB
AA1403167-E6 1591 nm 70 km 10 dB
AA1403168-E6 1611 nm 70 km 10 dB
* Achievable link distance is primarily dependent on cable plant insertion loss. 70 km is not possible
in some situations.
The following table lists the transmitter and receiver specifications for the 10GBASE CWDM DDI
SFP+ (70 km) transceiver.
Table 30: 10GBASE-ZR CWDM DDI SFP+ specifications
Parameter Specifications
Transmitter characteristics
Optical Data Rate (nominal) 9.95 Gbps to 10.313 Gbps
Center wavelength Nominal –6.5 nm to nominal +6.5 nm
Spectral width (RMS at –20 dB) 1 nm
RIN OMA –128 dB/Hz
Extinction ratio (minimum) 8.2 dB
Tx output: Min Max Units
P_avg –1 4 dBm
OMA +0.7 — dBm
OMA-TDP –2.3 — dBm
TDP at 1400 ps dispersion 3 dB
Optical return loss tolerance 21 dB
Receiver characteristics
Wavelength range 1460 nm to 1620 nm
SFP+ specifications
May 2017 Installing Transceivers and Optical Components on VOSS 55
Comments on this document? [e-mail]