Installation Instructions

Autonegotiation
Use Autonegotiation to allow the device to automatically negotiate the best common data rate and
duplex mode to use between two Autonegotiation-capable Ethernet devices.
1000BASE-T SFP specifications
The 1000BASE-T SFP provides Gigabit Ethernet connectivity using a single eight-pin RJ-45
connector.
The 1000BASE-T SFP only operates at 1 Gigabits per second (Gbps) speed. Operation at 100 or 10
Megabits per second (Mbps) speeds are not supported.
The part number for this model is AA1419043-E6.
The maximum current requirement of the SFP is 375 milliamperes (mA) at 5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
Table 9: IEEE 802.3z 1000BASE-T SFP specifications
Parameter Specifications
Standards IEEE 802.3z, IEEE 802.3ab
Connectors RJ-45
Cabling CAT5E or better UTP
Distance Up to 100 m
1000BASE-SX DDI SFP specifications
The 1000BASE-SX DDI SFP transceiver has a reach of up to 550 m using 50 µm MMF, and of 275
m using 62.5 µm MMF. This SFP transceiver operates at 850 nm. The part number is AA1419048-
E6.
The following table describes standards, connectors, cabling, and distance for the 1000BASE-SX
DDI SFP transceivers.
Table 10: 1000BASE-SX SFP DDI (550 m) specifications
Parameter Specifications
Maximum electrical power consumption 1 watt (W)
Connector Duplex LC
Cabling MMF
Data rate 1.0 Gbps
Line rate (8B/10B code) 1.25 Gbps
Link optical power budget 7.5 dB
Transmitter characteristics
Launch power –9.5 to –4.0 dBm
Receiver characteristics
SFP
May 2017 Installing Transceivers and Optical Components on VOSS 34
Comments on this document? [e-mail]