Troubleshooting Guide

Variable definitions
Use the data in the following table to use the more command.
Variable Value
WORD<1–99> Specifies the file name to view. Provide the filename
in one of the following formats: a.b.c.d:<file>, /
intflash/<file>.
Use the data in the following table to use the show running-config command.
Variable Value
module <boot | cfm | cli| diag | fa | fhs | filter | ike | ip |
ipsec | ipv6 | isis | i-sid | lacp | lldp | macsec | mlt |
naap | nsna | ntp | poe | port | qos | radius | rmon |
slamon | macsec | slpp | spbm | stg | sys | tacacs |
vlan | web>
Specifies the command group for which you request
configuration settings.
verbose Specifies a complete list of all configuration
information about the switch.
Use the data in the following table to use the show interfaces gigabitEthernet command.
Variable Value
bridging {slot/port[-slot/port][,...]} Displays ports bridging statistics.
dhcp-relay {slot/port[-slot/port][,...]} [vrf WORD<1–
16>][vrfids WORD<0–512>]
Displays port Dynamic Host Configuration Protocol
(DHCP) statistics.
lacp {slot/port[-slot/port][,...]} Displays Link Aggregation Control Protocol (LACP)
statistics.
policer {slot/port[-slot/port][,...]} Displays policer statistics.
rmon {slot/port[-slot/port][,...]}[history Displays Remote Network Monitoring (RMON)
statistics.
verbose {slot/port[-slot/port][,...]} Displays a complete list of all statistics.
Use the data in the following table to use the show interfaces gigabitEthernet error
command.
Variable Value
collision Displays port collision error information.
verbose Dsiplays all port error information.
{slot/port[-slot/port][,...]} Specifies the port.
Using ACLI for troubleshooting
January 2017 Troubleshooting 99
Comments on this document? [e-mail]