Troubleshooting Guide

Variable Value
contact WORD<0–255> Changes the sysContact information for Virtual Services
Platform 4000. WORD<0-255> is an ASCII string from 0–255
characters (for example a phone extension or e-mail address).
force-iphdr-sender enable Automatically configures the SNMP and IP sender to the same
value. The default is no force-iphdr-sender enable.
force-trap-sender enable Sends the configured source address (sender IP) as the sender
network in the notification message.
groupWORD<1–32>[WORD<0–32>]
[auth-no-priv|auth-priv|no-auth-no-priv]
[notify-viewWORD<0–32>|read-
viewWORD<0–32>|write-viewWORD<0–
32>]
Creates a new user group.
• auth-no-priv|auth-priv|no-auth-no-priv – Assigns the minimum
level of security required to gain the access rights allowed by
this conceptual row. If the no-auth-no-priv parameter is
included, it creates three entries, one for SNMPv1 access,
one for SNMPv2c access, and one for SNMPv3 access.
• WORD<1–32> WORD<1–32> – The first WORD<1–32>
specifies the group name for data access. The second
WORD<1–32> specifies the context name.
• notify-view WORD<0–32>|read-viewWORD<0–32>|write-view
WORD<0–32> – Specifies the view name.
hostWORD<1–256>[port<1–65535>][v1|
v2c|v3][WORD<1–32>][filter WORD<1–
32>][inform][mms<1-2147483647>]
[retries <0-255>]
[timeout<1-2147483647>] [noAuthPriv|
authNoPriv|authPriv]
Configures hosts to receive SNMP notifications.
• host WORD<1-256>— Specifies the IPv4 or IPv6 host
address.
• port <1-65535>—Specifies the port number.
• v1 WORD<1-32>—Specifies the SNMP v1 security name.
• v2c WORD<1-32>—Specifies the SNMPv2 security name.
• inform—Specifies the notify type.
• timeout <1-2147483647>—Specifies the timeout value.
• retries <0-255>—Specifies the number of retries.
• mms <1-2147483647>—Specifies the maximum message
size.
• v3 —Specifies SNMPv3
• noAuthPriv|authNoPriv|authPriv —Specifies the security level.
• WORD<1-32>—Specifies the user name.
• filter—Specifies a filter profile name.
locationWORD<0–255> Configures the sysLocation information for the system. <WORD
0-255> is an ASCII string from 0–255 characters.
login-success-trap enable Enables the generation of login-success traps.
nameWORD<0–255> Configures the sysName information for the system. <WORD
0-255> is an ASCII string from 0–255 characters.
Table continues…
Configuring SNMP interfaces
January 2017 Troubleshooting 69
Comments on this document? [e-mail]