Troubleshooting Guide

Name Description
OperState Specifies the operational state of the syslog service. The default is
active.
Header Specifies the IP header in syslog packets to circuitlessIP, default,
or managementVIP.
• If the value is circuitlessIP, the circuitless IP address is used in
the IP header for all syslog messages (in-band or out-of-band).
If you configure multiple circuitless IPs, the first circuitless IP
configured is used.
The default value is default.
Configuring the system log table
About this task
Use the system log table to customize the mappings between the severity levels and the type of
alarms.
You can log system log messages to external system log hosts with both IPv4 and IPv6 addresses
with no difference in functionality or configuration except in the following case. When you configure
the system log table, under the System Log Table tab, you must select ipv4 or IPv6 in the
AddressType box. The Address box supports both IPv4 and IPv6 addresses.
Procedure
1. In the navigation tree, expand the following folders: Configuration > Edit > Diagnostics.
2. Click System Log.
3. Click the System Log Table tab.
4. Click Insert.
5. Configure the parameters as required.
6. Click Insert.
7. To modify mappings, double-click a parameter to view a list of options.
8. Click Apply.
System Log Table field descriptions
Use the data in the following table to use the System Log Table tab.
Name
Description
Id Specifies the ID for the syslog host. The range is 1–10.
Table continues…
Log configuration using EDM
January 2017 Troubleshooting 64
Comments on this document? [e-mail]