Troubleshooting Guide

Configuring logging
Before you begin
• You must log on to the Global Configuration mode in ACLI.
About this task
Configure logging to determine the types of messages to log and where to store the messages.
Note:
The platform logs CLILOG and SNMPLOG as INFO. Normally, if you configure the logging level
to WARNING, the system skips all INFO messages. However, if you enable CLILOG and
SNMPLOG the system logs ACLI Log and SNMP Log information regardless of the logging level
you set. This is not the case for other INFO messages.
Procedure
1. Define which messages to log:
logging level <0-4>
2. Write the log file from memory to a file:
logging write WORD<1-1536>
3. Show logging on the screen:
logging screen
Example
VSP-4850GTS-PWR+:1(config)#logging level 0
VSP-4850GTS-PWR+:1(config)#logging write log2
VSP-4850GTS-PWR+:1(config)#logging screen
Variable definitions
Use the data in the following table to use the logging command.
Table 9: Variable definitions
Variable Value
level <0-4> Shows and configures the logging level. The level is one of the
following values:
• 0: Information — all messages are recorded
• 1: Warning — only warning and more serious messages are
recorded
• 2: Error — only error and more serious messages are
recorded
Table continues…
Configuring logging
January 2017 Troubleshooting 53
Comments on this document? [e-mail]