Troubleshooting Guide

Variable definitions on page 324
Variable definitions
Use the data in the following table to use the show i-sid command.
Variable Value
elan Displays all ELAN I-SIDs.
Use the data in the following table to use the show mlt i-sid command.
Variable Value
<1–512> The valid range for MLT ID.
Use the data in the following table to use the show interfaces gigabitEthernet i-sid
command.
Variable Value
{slot/port[/sub-port] [-slot/port[/
sub-port]] [,...]}
Identifies the slot and port in one of the following formats: a single slot
and port (slot/port), a range of slots and ports (slot/port-slot/port), or a
series of slots and ports (slot/port,slot/port,slot/port). If your platform
supports channelization for 40 Gbps ports and the port is channelized,
you must also specify the sub-port in the format slot/port/sub-port.
Related links
Displaying Switched UNI (ELAN) I-SID information on page 321
Troubleshooting Fabric Attach using the EDM
Verify configuration of Fabric Attach
Configuring Fabric Attach globally
Use this procedure to configure FA globally or view existing FA global configuration.
Procedure
1. In the navigation pane, navigate to Configuration > Edit > Fabric Attach.
2. In the content pane, click the Globals tab.
3. To enable or disable the Fabric Attach service, click enabled or disabled in the Service
field.
Troubleshooting Fabric Attach
January 2017 Troubleshooting 324
Comments on this document? [e-mail]