Troubleshooting Guide

show fa assignment [{slot/port[/sub-port] [-slot/port[/sub-port]]
[,...]}]
Example
The following example displays a sample output for the show fa assignment command.
Note:
The state of I-SID-to-VLAN assignments on a client or proxy device is pending until it is
changed by the FA Server to active or reject.
Switch:>en
Switch:1#show fa assignment
=======================================================================
Fabric Attach Assignment Map
=======================================================================
Interface I-SID Vlan State Origin
-----------------------------------------------------------------------
1/1 2 2 active proxy
1/2 3 3 active proxy
1/2 4 4 active proxy
1/3 5 5 reject proxy
-----------------------------------------------------------------------
4 out of 4 Total Num of fabric attach assignment mappings displayed
-----------------------------------------------------------------------
Related links
Troubleshooting Fabric Attach on page 309
Variable definitions on page 321
Variable definitions
Use the data in the following table to use the show fa assignment command.
Variable Value
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} Identifies the slot and port in one of the following
formats: a single slot and port (slot/port), a range of
slots and ports (slot/port-slot/port), or a series of
slots and ports (slot/port,slot/port,slot/port). If your
platform supports channelization for 40 Gbps ports
and the port is channelized, you must also specify
the sub-port in the format slot/port/sub-port.
Related links
Viewing Fabric Attach I-SID-to-VLAN assignments on page 320
Displaying Switched UNI (ELAN) I-SID information
Use this procedure to display information on FA-created Switched UNI (ELAN) I-SIDs.
Procedure
1. Enter Privileged EXEC mode:
Troubleshooting Fabric Attach using the ACLI
January 2017 Troubleshooting 321
Comments on this document? [e-mail]