Troubleshooting Guide

show fa elements [{slot/port[/sub-port] [-slot/port[/sub-port]]
[,...]}]
Example
The following example displays the sample output for the show fa elements command.
Switch:1#show fa elements
================================================================================
Fabric Attach Discovery Elements
================================================================================
MGMT ELEM ASGN
PORT TYPE VLAN STATE SYSTEM ID AUTH AUTH
--------------------------------------------------------------------------------
1/5 proxy 710 T / S 50:61:84:ee:8c:00:20:00:00:01 AP AP
1/6 proxy 710 T / S 50:61:84:ee:8c:00:20:00:00:01 AP AP
================================================================================
Fabric Attach Authentication Detail
================================================================================
ELEM OPER ASGN OPER
PORT AUTH STATUS AUTH STATUS
--------------------------------------------------------------------------------
1/5 successAuth successAuth
1/6 successAuth successAuth
State Legend: (Tagging/AutoConfig)
T= Tagged, U= Untagged, D= Disabled, S= Spbm, V= Vlan, I= Invalid
Auth Legend:
AP= Authentication Pass, AF= Authentication Fail,
NA= Not Authenticated, N= None
--------------------------------------------------------------------------------
2 out of 2 Total Num of fabric attach discovery elements displayed
Related links
Troubleshooting Fabric Attach on page 309
Viewing Fabric Attach statistics
If FA discovery fails, use this procedure to display FA statistics to determine if FA discovery TLVs
were processed. You can also view the FA assignment statistics to determine the number of FA
assignments that were accepted or rejected by the FA Server.
You can view the statistics at either the global level or at the port (interface) level.
Procedure
1. Enter Privileged EXEC mode:
enable
2. View global level FA statistics:
show fa statistics [summary]
Troubleshooting Fabric Attach using the ACLI
January 2017 Troubleshooting 317
Comments on this document? [e-mail]