Troubleshooting Guide

Procedure
1. Enter Privileged EXEC mode:
enable
2. To verify that FA is enabled globally, enter one of the following commands:
•
show fa
•
show fa agent
3. To view all FA interfaces (ports and MLTs), enter:
show fa interface
4. To view FA interface configuration on ports, use one of the following commands:
• To view FA configuration on all ports, enter:
show fa interface port
• To view FA configuration on a specific port, enter:
show fa interface port [{slot/port[/sub-port] [-slot/port[/sub-
port]] [,...]}]
5. To view FA interface configuration on MLTs, use one of the following commands:
• To view FA configuration on all MLTs, enter:
show fa interface mlt
• To view FA configuration on a specific MLT, enter:
show fa interface mlt [<1-512>]
• To view FA interface configuration based on the authentication status, enter:
show fa interface [enabled-auth] [disabled-auth]
Example
Verify that FA is configured globally.
Switch:1#show fa
===================================================================
Fabric Attach Configuration
===================================================================
FA Service : enabled
FA Element Type : server
FA Assignment Timeout : 240
FA Discovery Timeout : 240
FA Provision Mode : spbm
Verify FA configuration at the interface (port or MLT) level, on all interfaces.
In the following example output, note that:
• FA is enabled on interfaces 2/10, 4/11 and Mlt2.
• Both FA and message authentication are disabled on port 4/6.
Troubleshooting Fabric Attach
January 2017 Troubleshooting 310
Comments on this document? [e-mail]