Troubleshooting Guide

Viewing MACsec status
Perform this procedure to view MACsec status.
About this task
This command displays the status for the following:
• MACsec status
• MACsec encryption status
• The associated Connectivity Association (CA) name
Note:
If you do not specify a port number, the information on all MACsec capable interfaces is
displayed.
Procedure
1. Enter Privileged EXEC mode:
enable
2. View the MACsec status:
show macsec status {slot/port[/sub-port][-slot/port[/sub-port]]
[,...]}
Example
View the MACsec status:
Note:
The current release does not support replay protect.
Switch:1>enable
Switch:1#show macsec status
===========================================================================
MACSEC Port Status
===========================================================================
MACSEC Encryption Replay Replay Encryption CA
PortId Status Status Protect Protect W'dow Offset Name
---------------------------------------------------------------------------
1/49 enabled enabled disabled -- ipv4Offset(30) ca333
1/50 disabled disabled disabled -- none Nil
Switch:1#show macsec status 1/49
===========================================================================
MACSEC Port Status
===========================================================================
MACSEC Encryption Replay Replay Encryption CA
PortId Status Status Protect Protect W'dow Offset Name
---------------------------------------------------------------------------
1/49 enabled enabled disabled -- ipv4Offset(30) ca333
Viewing MACsec status
January 2017 Troubleshooting 307
Comments on this document? [e-mail]