Troubleshooting Guide

300 4.01.18 10 b4a9.5a2a.d065 discover Switch2
--------------------------------------------------------------------------------
Total number of SPBM ISID entries configured: 1
--------------------------------------------------------------------------------
Total number of SPBM ISID entries discovered: 1
--------------------------------------------------------------------------------
Total number of SPBM ISID entries: 2
--------------------------------------------------------------------------------
Variable definitions
Use the data in the following table to use the show i-sid command.
Note:
When SPB is enabled, I-SID IDs 16777216 and greater are reserved for dynamic data I-SIDs,
used to carry Multicast traffic over SPB.
Table 57: Variable definitions
Variable Value
<1–16777215> Specifies the service interface identifier (ISID). The
ISID range is <1–16777215>.
elan-transparent Displays only all the Elan-Transparent (T-UNI based)
ISIDs.
spbm i-sid {all|config|discover} • all: displays all I-SID entries
• config: displays configured I-SID entries
• discover: displayes discovered I-SID entries
vlan <1–4094> Displays I-SID information for the specified SPBM
VLAN.
id <1–16777215> Displays I-SID information for the specified I-SID.
nick-name <x.xx.xx> Displays I-SID information for the specified
nickname.
Job aid
The following table describes the fields in the output for the show i-sid command.
Table 58: show i-sid
Field
Description
ISID ID Specifies the service interface identifier (I-SID)
ISID TYPE Specifies the type of I-SID
Table continues…
Transparent Port UNI feature troubleshooting using ACLI
January 2017 Troubleshooting 300
Comments on this document? [e-mail]