Troubleshooting Guide

Procedure
1. In the navigation pane, expand the following folders: Configuration > IP.
2. Click IGMP.
3. Click the Snoop Trace tab.
Snoop Trace field descriptions
Use the data in the following table to use the Snoop Trace tab.
Name Description
GrpAddr Displays the IP multicast address of the group
traversing the router.
SrcAddr Displays the IP source address of the multicast
group.
OutVlan Displays the egress VLAN ID for the multicast group.
InPort Displays the ingress port for the multicast group.
InVlan Displays the ingress VLAN ID for the multicast
group.
OutPort Displays the egress port of the multicast group.
Type Displays the port type on which the snoop entry is
learned.
Viewing IGMP group information
View information about IGMP groups to see the current group operation on the switch.
About this task
Note:
The following procedure displays the dynamically learned IGMP groups. IP > IGMP > Static
displays statically configured IGMP groups. This is in contrast to the ACLI command show ip
igmp group, which displays both dynamically learned and statically configured IGMP groups,
and the ACLI command show ip igmp static, which displays only the statically configured
groups.
You can view IGMP information on a VRF instance the same way you view the Global Router
except that you must first launch the appropriate VRF context.
Procedure
1. In the navigation pane, expand the following folders: Configuration > IP.
2. Click IGMP.
Viewing IGMP group information
January 2017 Troubleshooting 293
Comments on this document? [e-mail]